Difference between revisions of "EGR 224/Spring 2011"
Jump to navigation
Jump to search
| (14 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | [[EGR | + | [[EGR 224]] is a required course for all students planning to earn a Bachelor of Science in Engineering Degree with the Department of Mechanical Engineering and Material Science at Duke University. It can also be taken as an elective by students in the Civil and Environmental Engineering Department who want their out-of-depertment course to focus on electronics, signal processing, and sensing. This page is meant to provide answers to general questions about the course, not necessarily specific questions about content. There is also a [[:Category:EGR 224]] that will list all pages relevant to EGR 224. Note at the bottom of this page that it is a member of that category. |
| − | Students in EGR | + | Students in EGR 224 may also want to check out the [[Welcome Back]] page. |
== Support Pages for Spring 2011 == | == Support Pages for Spring 2011 == | ||
| − | * See [[:Category:EGR | + | * See [[:Category:EGR 224]] |
* Homework | * Homework | ||
<!-- | <!-- | ||
| Line 10: | Line 10: | ||
--> | --> | ||
* Labs | * Labs | ||
| − | |||
** Lab 1 - Solving Circuit Equations Using xMaple - [[Maple]] | ** Lab 1 - Solving Circuit Equations Using xMaple - [[Maple]] | ||
** Lab 2 - Electrical Circuits and Measurements - [[MS8264]], [[PBB 272]], [[Resistor Color Codes]] | ** Lab 2 - Electrical Circuits and Measurements - [[MS8264]], [[PBB 272]], [[Resistor Color Codes]] | ||
| + | ***Note - due to some disappearances in the lab, the directions for the changed with respect to the color of the patch cables you are using. If you printed out the lab before 10PM on Monday, you will need to make the changes below; otherwise, the "new" version has the changes already... For the old version, in the '''Equipment''' section, this means that there will be a total of FIVE cables, not six: | ||
| + | **** Black, Red, and Yellow connected to PBB Ground, +15, and -15 already | ||
| + | **** Green and White in the toolbox. Use the Green cable in place of the Red cable that attached to the red lead on the multimeter and use the White cable in place of the Black cable that attached to the black lead on the multimeter. | ||
| + | **** Other places this comes into play are | ||
| + | ***** 2.1 second paragraph | ||
| + | ***** First, third, and fifth paragraph on page 2-3 | ||
** Lab 3 - Solving Circuits with Capacitors - [[Maple]] | ** Lab 3 - Solving Circuits with Capacitors - [[Maple]] | ||
| − | ** Lab 4 - RC Circuits and Filtering - [[EGR | + | ** Lab 4 - RC Circuits and Filtering - [[EGR 224/RC Lab| RC Lab notes and pictures]] |
| − | ** Lab 5 - Operational Amplifiers - [[EGR | + | ** Lab 5 - Operational Amplifiers - [[EGR 224/Operational Amplifiers|Operational Amplifiers]] |
| − | ** Lab 6 - | + | |
| + | ** Lab 6 - [[Maple]], [[Maple/Laplace Transforms| Laplace Transforms in Maple]] | ||
| + | <!-- | ||
| + | |||
***Typo 1: The ILTS command in the box on page 1 of the handout has an extra ) after the X in the invlaplace command. | ***Typo 1: The ILTS command in the box on page 1 of the handout has an extra ) after the X in the invlaplace command. | ||
***Typo 2: in the first part of the second problem, you are looking for the voltage across the capacitor, not anything about current... | ***Typo 2: in the first part of the second problem, you are looking for the voltage across the capacitor, not anything about current... | ||
--> | --> | ||
* Lectures: | * Lectures: | ||
| − | ** [[EGR | + | ** [[EGR 224/Spring 2011/Lectures| Questions about specific lectures]] |
| + | ** Lecture 10: Sinusoids and Phasors - [[Complex Numbers]] | ||
| + | ** [[EGR_119/Active_Filter | Active Filter Supporting Page]] | ||
<!-- | <!-- | ||
| − | + | ||
--> | --> | ||
* Test Reviews | * Test Reviews | ||
| + | ** Test I: [[EGR 224/Spring 2011/Test 1|Topics]], [[Talk:EGR 224/Spring 2011/Test 1|Discussion]] | ||
| + | ** Test II: [[EGR 224/Spring 2011/Test 2|Topics]], [[Talk:EGR 224/Spring 2011/Test 2|Discussion]] | ||
| + | ** Final: [[EGR 224/Spring 2011/Final|Topics]], [[Talk:EGR 224/Spring 2011/Final|Discussion]] | ||
<!-- | <!-- | ||
| − | |||
| − | |||
| − | |||
--> | --> | ||
<!-- | <!-- | ||
* | * | ||
| − | * | + | * |
| − | * [[EGR | + | * [[EGR 224/Simulink Lab | Simulink Lab Supporting Page]] |
| − | * Test 2 ([[EGR | + | * Test 2 ([[EGR 224/Spring 2009/Test 2|Review]], [[Talk:EGR 224/Spring 2009/Test 2|Discussion]], [[EGR 224/Spring 2009/Test 2/Post Test|Post-Test]]) |
* Final ([[EGR_119/Spring_2009/Final|Review]], [[Talk:EGR_119/Spring_2009/Final|Discussion]]) | * Final ([[EGR_119/Spring_2009/Final|Review]], [[Talk:EGR_119/Spring_2009/Final|Discussion]]) | ||
--> | --> | ||
| Line 49: | Line 59: | ||
== External Links == | == External Links == | ||
| − | * [http://classes.pratt.duke.edu/ | + | * [http://classes.pratt.duke.edu/EGR119S12 http://classes.pratt.duke.edu/EGR119S12] - Dr. G's Spring 2012 Class Page |
* [http://courses.duke.edu http://courses.duke.edu] - Duke's BlackBoard site | * [http://courses.duke.edu http://courses.duke.edu] - Duke's BlackBoard site | ||
== References == | == References == | ||
<references /> | <references /> | ||
| − | |||
| − | |||
Latest revision as of 18:02, 8 January 2018
EGR 224 is a required course for all students planning to earn a Bachelor of Science in Engineering Degree with the Department of Mechanical Engineering and Material Science at Duke University. It can also be taken as an elective by students in the Civil and Environmental Engineering Department who want their out-of-depertment course to focus on electronics, signal processing, and sensing. This page is meant to provide answers to general questions about the course, not necessarily specific questions about content. There is also a Category:EGR 224 that will list all pages relevant to EGR 224. Note at the bottom of this page that it is a member of that category.
Students in EGR 224 may also want to check out the Welcome Back page.
Contents
Support Pages for Spring 2011
- See Category:EGR 224
- Homework
- Labs
- Lab 1 - Solving Circuit Equations Using xMaple - Maple
- Lab 2 - Electrical Circuits and Measurements - MS8264, PBB 272, Resistor Color Codes
- Note - due to some disappearances in the lab, the directions for the changed with respect to the color of the patch cables you are using. If you printed out the lab before 10PM on Monday, you will need to make the changes below; otherwise, the "new" version has the changes already... For the old version, in the Equipment section, this means that there will be a total of FIVE cables, not six:
- Black, Red, and Yellow connected to PBB Ground, +15, and -15 already
- Green and White in the toolbox. Use the Green cable in place of the Red cable that attached to the red lead on the multimeter and use the White cable in place of the Black cable that attached to the black lead on the multimeter.
- Other places this comes into play are
- 2.1 second paragraph
- First, third, and fifth paragraph on page 2-3
- Note - due to some disappearances in the lab, the directions for the changed with respect to the color of the patch cables you are using. If you printed out the lab before 10PM on Monday, you will need to make the changes below; otherwise, the "new" version has the changes already... For the old version, in the Equipment section, this means that there will be a total of FIVE cables, not six:
- Lab 3 - Solving Circuits with Capacitors - Maple
- Lab 4 - RC Circuits and Filtering - RC Lab notes and pictures
- Lab 5 - Operational Amplifiers - Operational Amplifiers
- Lab 6 - Maple, Laplace Transforms in Maple
- Lectures:
- Questions about specific lectures
- Lecture 10: Sinusoids and Phasors - Complex Numbers
- Active Filter Supporting Page
- Test Reviews
- Test I: Topics, Discussion
- Test II: Topics, Discussion
- Final: Topics, Discussion
F.A.Q.
None Yet
Resources
- Wikipedia page on Cramer's Rule; includes demos for two and three variable systems.
Questions
Post your questions by editing the discussion page of this article. Edit the page, then scroll to the bottom and add a question by putting in the characters *{{Q}}, followed by your question and finally your signature (with four tildes, i.e. ~~~~). Using the {{Q}} will automatically put the page in the category of pages with questions - other editors hoping to help out can then go to that category page to see where the questions are. See the page for Template:Q for details and examples.
External Links
- http://classes.pratt.duke.edu/EGR119S12 - Dr. G's Spring 2012 Class Page
- http://courses.duke.edu - Duke's BlackBoard site
